Torque execution configuration discussion » History » Revision 4
Revision 3 (Nguyen Cao Nguyen, 09/07/2026 01:21 PM) → Revision 4/5 (Nguyen Cao Nguyen, 09/07/2026 03:48 PM)
# Torque execution configuration discussion ## Spec: Server Tolerance `+4%/-0%` `+/-4 %` target torque display | Status: WIP TV5 ``` Tighten: access code {5,5,1,1} → SCREEN_CFG_TORQUE_TIGHTEN_WARN_TOLERANCE Over: access code {5,5,2,1} → SCREEN_CFG_TORQUE_OVER_WARN_TOLERANCE #define GOOD_TORQUE_ZONE_LIMIT_L_DEFAULT 100 // Config & Store in Flash mode Code: {5,5,1,1} #define OVER_TORQUE_ZONE_LIMIT_L_DEFAULT 115 // Config & Store in Flash mode Code: {5,5,2,1} ``` ---> Device wrench must define tolerance Use case target 100 ft-lb tolerance +/-4% = 96 -> 104 => **+4%/-0%** Example bad use case: --> Server define: 100 -> 96 - 104 --> Device: 100 - 106 ===> Server 105, 106 display(NG) `$FINISH_WO;<type_of_device>;<workOrderID>;<status>;<unit>; <tolerance_low>; <tolerance_high> ;<nut>;<wheel>;<t0>;...;<tn>[;<wheel>;...]\n00cr16#\n` tolerance(Unit: %): ;96;104; Server display **Torque measurement results table** @Truong ## Reference - [OTW Code](https://torquevault.atlassian.net/wiki/x/DYAiBw)