Torque execution configuration discussion¶

Spec: Server Tolerance +4%/-0% target torque display | Status: WIP¶

TV5

Tighten: access code {5,5,1,1} → SCREEN_CFG_TORQUE_TIGHTEN_WARN_TOLERANCE
Over: access code {5,5,2,1} → SCREEN_CFG_TORQUE_OVER_WARN_TOLERANCE
#define GOOD_TORQUE_ZONE_LIMIT_L_DEFAULT    100  // Config & Store in Flash mode Code: {5,5,1,1}
#define OVER_TORQUE_ZONE_LIMIT_L_DEFAULT    115  // Config & Store in Flash mode Code: {5,5,2,1}

---> Device wrench must define tolerance
Use case target 100 ft-lb tolerance +/-4% = 96 -> 104 => +4%/-0%

Example bad use case:
--> Server define: 100 -> 96 - 104
--> Device: 100 - 106 ===> Server 105, 106 display(NG)

$FINISH_WO;<type_of_device>;<workOrderID>;<status>;<unit>;<tolerance_low>;<tolerance_high>;<nut>;<wheel>;<t0>;...;<tn>[;<wheel>;...]\n00cr16#\n
tolerance(Unit: %): ;96;104;
Server display Torque measurement results table @Truong

Reference¶

• OTW Code