DTS Project Overview

# Torque execution configuration discussion

## Spec: Server Tolerance `+4%/-0%` target torque display | Status: WIP

TV5

```

Tighten: access code {5,5,1,1} → SCREEN_CFG_TORQUE_TIGHTEN_WARN_TOLERANCE

Over: access code {5,5,2,1} → SCREEN_CFG_TORQUE_OVER_WARN_TOLERANCE

#define GOOD_TORQUE_ZONE_LIMIT_L_DEFAULT    100  // Config & Store in Flash mode Code: {5,5,1,1}

#define OVER_TORQUE_ZONE_LIMIT_L_DEFAULT    115  // Config & Store in Flash mode Code: {5,5,2,1}

```

---> Device wrench must define tolerance

Use case target 100 ft-lb tolerance +/-4% = 96 -> 104 => **+4%/-0%** 

Example bad use case:

--> Server define: 100 -> 96 - 104

--> Device:            100 - 106 ===> Server 105, 106 display(NG)

`$FINISH_WO;<type_of_device>;<workOrderID>;<status>;<unit>; <tolerance_low>; <tolerance_high> ;<nut>;<wheel>;<t0>;...;<tn>[;<wheel>;...]\n00cr16#\n`

tolerance(Unit: %): ;96;104;

Server display **Torque measurement results table** @Truong 

## Reference

 - [OTW Code](https://torquevault.atlassian.net/wiki/x/DYAiBw)